1.移动式皮带运输机运转作业前，， ，，，应将行走轮用三角木对称楔紧。。 。。。牢靠式皮带运输机，， ，，，应装置在牢靠的基础上。。 。。。
2.起动前，， ，，，调解好办减速这松紧度，， ，，，带扣应牢靠，， ，，，轴承、齿轮、链条等传动部件应优异，， ，，，托轮和防护装置应齐全，， ，，，电器接地(接零)保�；；；；び乓�，， ，，，运送带与滚筒宽度应一致。。 。。。
3.应先空载起动，， ，，，待运转正常后，， ，，，方可匀称装料，， ，，，不得先装料后起动。。 。。。
4.作业中，， ，，，应随时注重机械的运转情形如发明运送带有松驰或走偏征象，， ，，，应停车举行调解或修理。。 。。。严禁在运转中举行修理和调解。。 。。。
5.作业时，， ，，，严禁任何职员从皮带运输机下面穿过或跨越运送带。。 。。。运送带打滑时，， ，，，不得用手颤抖拉动。。 。。。
6.运送大块物料时，， ，，，运送带两侧应加装档板或栅栏等防护装置。。 。。。
7.运转中需要停�；；；；�，， ，，，应先阻止装料，， ，，，待运送带上料卸尽后，， ，，，方可停�；；；；�。 。。。
8.遇电源突然中止或其它缘故原由突然停车，， ，，，应连忙切断电源，， ，，，然后将皮带上的物料扫除掉，， ，，，等来电或扫除故障后，， ，，，再接通电源启动运转。。 。。。
9.停车前必需先与有关方面联系，， ，，，待运送带上的物料完全卸掉后，， ，，，方可停�；；；；�。 。。。
10.停�；；；；笥η卸系缭�，， ，，，锁好电源开关箱，， ，，，对机械各部举行保养。。 。。。用防雨护罩将电念头盖好。。 。。。
中译英：
1 mobile belt conveyor running before the work, should the walking wheel with wooden triangle symmetric wedge. Fixed belt conveyer, should be installed on a solid basis.
2 before starting, adjustment of the tightness of the easy reduction, buckle should be firm, bearing, gear, chain and other transmission parts should be good, the supporting wheel and the protective device should be complete, electrical grounding ( zero) to protect the good, the belt and the roller width should be consistent.
3 first no-load starting, to be in normal operation, can be uniformly charging, not to charge after starting.
4 work, should always pay attention to mechanical running condition such as found in conveyor with relaxation or off phenomenon, should stop adjustment or repair. Is strictly prohibited in the operation for repair and adjustment.
5 operations, and forbids any personnel from the belt conveyor below through or across the conveyor belt. The conveying belt, not to hand shake pulling.
6 conveyor bulk materials, two sides of the conveyer should install baffles or fence protective device.
7 operation need to stop, should stop charging, stay on the conveyor belt after discharge, before shutdown.
8 in the event of power supply is suddenly broken or other causes of sudden stop, should be immediately cut off the power supply, then the belt material removed, such as call or after troubleshooting, and then turn on the power supply to start running.
9 parking must be concerned with relation to the conveyor belt, the material is fully unloaded, before shutdown.
10 stops should be cut off the power supply, power lock switch box, the Department of mechanical maintenance. Rainproof cover for motor cover.
(图/文www.changrong-jx.com)
|
VR全景 
苏公网安备 32020602000237号